17
Wiring
(continued)
HC5: White 5-Pin Accessory Harness
(continued)
Dome Light Control Output :
This wire becomes grounded when the alarm is
disarmed. The current capacity of this wire is
200mA. This wire can control the operation of the
interior lights. Use of optional relay as shown is
recommended.
A. Upon disarming, the interior lights will remain
on for 30 seconds.
B. If the vehicle is violated, the interior light will
flash for the same duration as the siren.
Horn Output (See “Alarm Feature Programming”):
This wire can be used to activate the existing
vehicle’s horn as the alarm system’s optional
warning audible device. It’s a transistorized low
current output, and should only be connected to
the low current ground output from the vehicle’s
horn switch. When the system is triggered, the
horn will sound (depending on the vehicle’s
requirement an additional relay may be required as
shown).
Factory Security Rearm Signal Output (See “Alarm Feature Programming”):
This wire can be used to rearm a factory installed security system. This wire will supply a pulse whenever the
remote start times out or is shut down using the transmitter and remote door locking.
Ground Output During Crank (See “Alarm Feature Programming”):
This wire can be used to control another device as needed when the remote start is cranking the engine.
This wire will supply a constant ground while the engine is cranking.
The Blue/White will pulse a ground signal when the vehicle is running by remote starter. Locate the defroster
trigger wire at the back of the defrost switch and make the connection.
The Red/White will become grounded for
1 second when activated by the remote trans-
mitter. The current capacity of this wire is
200mA and may require an additional relay to
operate properly.
87
87a
86
85
30
Black/White
Wire
White
5-Pin Mini
Connector
+12V
Courtesy
Light
Door
Switch
Fuse
+12 Volts or Ground Depending
on Vehicle Requirement
Black/White Wire : (-) 200mA Programmable Output (Dome Light Supervision Default)
Blue/White Wire : (-) Defroster Output
Red/White Wire : Channel 3 (Trunk Release) Output
87
87a
86
85
30
To Horn
+12V or Ground
Depending on
System Requirements
Fuse
+12V
Black/White
Wire
White
5-Pin Mini
Connector
87
86
85
30
(Relay Not Supplied)
Output to Power
Trunk Switch
To Co12 Volts
Input to Relay (+ or -)
White
5-Pin Mini
Connector
Red/White
Wire
