15
Wiring
(continued)
Transponder Key
87
87A
85
86
30
Ignition Switch
+12 Volt Ignition
Pink Wire
White 5-Pin Mini Connector
HC5: White 5-Pin Accessory Harness
Some late model vehicles require (2)
START outputs from the ignition key
to start the vehicle. The Violet/Yellow
wire will become grounded when the
remote start is activated. This is a low
current output wire and will require a
30a/40a relay (not supplied) for
correct operation. Wire the relay as
shown.
Some newer vehicles use a third ignition
wire which is required to start and keep
the vehicle’s engine running. The Pink
wire provides a 200mA (-) ground
output that becomes active 4 seconds
before the remote start unit initializes.
This wire remains grounded while the
engine is running. This is a low current
output wire and will require a 30a/40a
relay (not supplied) for correct
operation. Wire the relay as shown.
Note: This wire can an also be used to control an ignition immobilizer bypass module.
Transponder Interfacing Using ALA984 Relay: Can also use optional RS-TIM bypass module.
If the vehicle has transponder system installed, you will need to bypass the system while the vehicle is operating
under the control of the Remote Start Unit. To do this, follow these steps:
1. You will need a transponder key that’s already programmed to the vehicle.
2. Remove the trim around the ignition switch.
3. Wrap a thin (30 awg) wire tightly around ignition switch 6 to 8 times and secure it.
4. About 6" down line make another loop of approximately 2" diameter.
5. Place the key inside this loop and secure it to the loop.
6. Connect on end of the 30 awg wire to pin (87) of the relay module.
7. Connect the other end of the loop wire to Pin (30) of relay module.
8. Connect (86) to ignition, connect (85) to the Yellow wire of 5-pin mini white connector.
87
87a
86
85
30
Violet/Yellow
Wire
+12 V Constant
Fused 25A Capable
Second Start Wire from
Ignition Key Switch
White
5-Pin Mini
Connector
87
87a
86
85
30
Pink
Wire
+12 V Constant
Fused 25A Capable
Ignition 3 Wire from
Ignition Key Switch
White
5-Pin Mini
Connector
Pink Wire : (-) 200mA Ignition 3 Output
Violet/Yellow Wire: (-) Second Start Output
