SUPER LOUD LCD ALARM CLOCK
Model: 31015
BATTERY INSTALLATION
The battery compartment is located on the bottom of the clock. Open the battery cover. Remove the battery cover and insert one
“AA” battery and one 9V battery according to the polarity indication inside the battery compartment. Replace the battery cover.
(Batteries not included)
TO SET THE TIME
To set the time, press and hold the Time Set Button (6) and the Hour Set Button (3) until the correct hour is displayed (and the
AM/PM is correct), then release the Hour Set button and press the Minute Set button (4) until the correct time is displayed.
TO SET THE ALARM TIME
To set the alarm time, press and hold the Alarm Set Button (5) and the Hour Set Button (3) or Minute Set button (4) as above.
Be sure to set the AM/PM properly too.
TO TURN THE ALARM ON
Slide the ALARM (1) Switch to the “ALARM ON” position. An “ALARM ON” indicator will appear in the display. The alarm will sound
at the desired hour.
TO STOP THE ALARM
When the alarm sounds, you can turn it OFF by sliding the ALARM (1) switch to the OFF” position. lf you do not turn the alarm off, it
will sound for 1 minute, then turn itself off and reset automatically for the next day.
TO USE THE SNOOZE
When the alarm sounds, simply press the SNOOZE/LIGHT (2) button. The alarm will stop and will sound again in approximately 4
minutes. You can continue to use the SNOOZE repeatedly and the alarm will sound 4 minutes after each time the SNOOZE/LIGHT (2)
button is pressed.
ALARM SOUND LEVEL
The alarm sound level can be selected as high or low, by sliding the Sound Level Switch [7] in the HI or LOW position.
NOTE: A 9V battery must be installed in order to have a high alarm sound output.
