28
9X + 1X (Hold)
Step 2
Step 1
3X
Enter the crank detection programming mode, select the engine checking type, then follow the procedures to test
and re-set the cranking parameters as needed.
Note: The default detection setting is “Voltage Detection”. Once your wiring is completed, you can press the
button (2) times and start the engine to make sure all your connections are good to this point.
With the ignition switch in the OFF position,
turn the ignition switch On - Off - On - Off - On -
Off.
Before 15 seconds has passed, push and release the valet
switch 10 times. Hold the button down on the 10th press. You
will hear 5 short chirps/beeps + 1 long chirp/beep. Release the
button. You are now in “Engine Crank Detection Programming”
mode.
Press
Buttons
Chirp/
LED Flash
Checking
Type
Follow Programming and Test Procedure
+
1
Voltage
Type
A. Press two times to start the engine. Allow engine to run for more
than 10 seconds.
B. If engine starts without cranking too long or too short and runs for more
than 10 seconds, press to exit programming mode (3 chirps confirm
exit). Programming is complete.
C. If the engine shuts off before 10 seconds, press to change “low
check level” to “hi check level” (2 chirps). Repeat A/B above.
D. If the engine cranks too long or too little, press to select a different
crank duration (see chart enclosed). Repeat A/B above.
Press
Buttons
Chirp/
LED Flash
Checking
Type
Follow Programming and Test Procedure
+
2
Tachometer
Type
A. Learn the engine idle RPM.
1. Start the engine with the ignition key and allow the choke to turn off.
2. With the engine at true idle speed, press and hold the valet switch
until you hear (1) long chirp and the LED is on solid for two seconds.
2A. If you do not get a response from holding down the valet switch,
check your tach connection. It may be loose or incorrect.
3. Turn off the ignition key.
B. Press two times to start the engine. Allow engine to run for more
than 10 seconds.
C. If engine starts without cranking too long, press to exit programming
mode (3 chirps confirm exit). Programming is complete.
D. If the engine cranks too long, press to change “high check level” to
“low check level” (1 chirps). Repeat B/C above.
Engine Crank Detection Programming
Step 3B Crank Detection Programming and Procedure
Step 3A Crank Detection Programming and Procedure
