Manitowoc Q130 series, Technician'S Handbook

Page: 69 / 236

Part Number 8001119 10/19 69
6. Wait until the Clean light flashes (3 minutes) then
add 0.5 oz (15 ml) of Manitowoc sanitizer by lifting
the water shutter and pouring directly into the
spray area. The ice machine will automatically
time out a ten minute cleaning cycle, followed by
eight rinse cycles, and stop. The Clean light will
turn off to indicate the Cleaning cycle is
completed. This entire cycle lasts approximately
30 minutes.
NOTE: The ice machine will automatically continue from the
previous point before the clean cycle was initiated.
Disconnect electric power to the ice machine at
the electric switch box before proceeding.
• If the ice machine was in the ice making cycle, the
control board will initiate a 2 minute harvest cycle,
perform the clean cycle and start ice making again
automatically.
• If the ice machine was in the off cycle, the control board
will perform a clean cycle and turn off automatically.
• If the ice machine was in a delay mode, the control board
will perform a clean cycle and resume the delay period
automatically.
REMOVAL OF PARTS FOR CLEANING AND
SANITIZING
1. Disconnect power to the ice machine at the
electric switch box.
2. Turn off the water supply to the ice machine at the
water service valve.
3. Remove the parts or components you want to
clean or sanitize:
WATER SHUTTERS
The water shutter is designed to keep the spraying
water from escaping the evaporator compartment.
To remove just the water shutters:
1. Grasp one end of the water shutter and lift up.
2. Pivot water shutter and disengage remaining end.
! Warning