■
STEAM FUNCTION MANAGEMENT
■
NO WATER IN THE TANK
Usually, if the tank is filled with 1.5 l of water, this should be enough for the entire
steam cooking cycle.
If not, the electronic system signals that the water is finished using an
intermittent audible signal and the corresponding water icon flashes
.
The oven automatically goes into .
Open the door, remove the tank and fill with potable water. Close the door and de-
activate the pause by pressing the 3 START .
The oven will restart from where it stopped.
NOTE: if the steam puff function was activated, the system gives 5 mins to perform
the water refill procedure. Once the 5 mins have passed, the system automatically
restarts the traditional cooking cycle, de-activating the steam puff function.
DRAIN WATER FROM THE BOILER
At the end of any steam cooking or cleaning cycle, the system always requires the water
to be drained from the boiler and thus the circuit. This keeps the system clean and
prevents limescale.
It is a quick and simple operation and keeps the circuit ready for a new steam cooking
cycle.
After cooking is complete, from the oven mode "on awaiting commands", press the 1
ON/OFF to turn the oven off.
An intermittent audible signal and the tank+water icon begin to flash
.
21
The oven does not turn completely off until the boiler circuit is emptied.
