STEP 1: INSTALLING THE LEFT & RIGHT LEG PANELS
1-1 Unbox both the left and right leg panels---indicated by the “L” and “R”
on the side of the boxes.
1-2 Unbox the backsplash and base tray. Set the backsplash (the thin flat
rectangle) aside for later installation.
1-3 Lay the base tray on an even surface.
1-4 Set the left end of the bottom shelf on its end so that the shelf is in a
vertical position. Place the right leg panel onto the right end of the bottom
shelf as shown in illustration Step 1-4.
Note: The corner cut outs on the bottom shelf will line-up with the
rear caster supports.
1-5 With the bottom shelf in place, use (4)
four 1/4” x 1/2” screws and lock washers
placed on the screw before installation.
Start with the farthest left screw hole on
the outside of the leg panel.
1-6 Secure the leg panel to the bottom
shelf by attaching a 1/2” x 20 lock nut to
the screw on the inside of the leg panel.
Finger tighten each of the screws.
1-7 Repeat steps 1-5 & 6 with the other screw holes on the leg panel.
Once the screws and nuts are attached, tighten firmly using the 5/32 hex
wrench.
ASSEMBLY INSTRUCTIONS
NOTE: The assembly of your MAK 2 Star Grill requires (2) two people.
Before starting the assembly process, remove the outer cardboard sleeve
surrounding the grill. Flatten the sleeve and use it to place the grill body
on during leg panel assembly. Be sure to remove ALL parts and
components from the grill and pallet before starting the assembly
process. Place the components in an area that allows you to get to them,
but does not interfere with assembling the grill.
NOTE: Lock washers should always be placed on the screws before
installing.
9
Step 1-4
10
1-8 When you are finished attaching the right leg panel to the bottom
shelf, lay the right leg panel down on top of the cardboard surround and
attach the left leg panel by repeating steps 1-4 through 1-6. You have
now completed assembling the grill cart.
1-9 After attaching the leg panels to the bottom shelf, use one other
person to help you set the grill cart upright. Before continuing, LOCK ALL
FOUR CASTERS to prevent the cart assembly from moving when
attaching the grill body to the cart.
STEP 2: ATTACHING THE BACKSPLASH
2-1 Note:
There are three screw holes and five larger holes for the leg
panel rivets. Please refer to illustration Step 2-1.
2-1 The backsplash can be attached to the grill leg panels only one way
allowing for the rivets to be seen. You may need to flip or rotate the panel
in order to correctly align the screw and
rivet holes for correct installation.
2-2 Take six 1/4”-20 x 1/2” screws and
place a 1/4” lock washer on each screw.
The nuts for the backsplash are welded to
the inside of the leg panels.
2-3 Thread each screw into the hole and
finger tighten.
NOTE: At this step the backsplash
should be loose on the grill cart. This is necessary to allow some
flexing when placing the grill body onto the cart assembly. You will
fully tighten the screws a little later on in the assembly process.
Step 2 - 1
Summary of Contents for EP-429-2G
Page 1: ...Front Cover...
Page 9: ...6 BBQ DIAGRAM...
