MAHA MPJ Series, Original Operating Instructions

Page: 64 / 114

64
BA550001-en
Fill with hydraulic oil
Step 1:
Oil quantities see also appendix
1 Remove the M14x1.5 screw plug (B).
2 Fill in the following partial quantities:
2S 11.5 l
3S 18.5 l
3 Close the oil filler opening with the screw plug.
Step 2:
1 Place a cloth around the piston rods below the bleed screw.
2 Remove the screw plug including the USIT sealing ring.
3 Immediately afterwards, screw in the bleeder valve and tighten it hand-tight
Ensure that the bleeder valve is closed (a small amount of hydraulic oil may
escape during this process).
4 Connect the pit jack to the compressed air network.
5 Actuate the
fast approach stroke and extend to the end stop. Wait approx.
10 seconds until no more escaping air can be heard.
6 Disconnect the pit jack from the compressed air supply.
7 Remove the filler plug, top up with a second portion of hydraulic oil and
screw the filler plug back in as described above.
2S 8.5 l
3S 21.5 l
B