e
n
g
li
s
h
InstallatIon
25
Installing disc brake rotor
Loss of insurance protection with S-Pedelecs (E-bikes up to 45 km/h)
that require insurance.
Use only original MAGURA brake pads and disc brake rotors
which have the ECE or KBA test certifications for vehicle compo-
nents subject to approval.
Never change the size of the disc brake rotors.
Danger of accident due to brake failure or sudden brake
lock-up due to excessive load.
Never mount disc brake rotors on S-Pedelecs, Pedelecs,
Cargo bikes or Tandems.
L
To install a Centerlock™ hub, the MAGURA
Centerlock adapter
is required.
)
Place disc brake rotor on the axle flange.
Ö
The direction arrows point in the direction of forward movement.
[
a5
]
)
Make sure that all retaining screws (not lock ring!) are coated
with fresh screwlock (medium strength).
)
Screw in retaining screws 2–3 threads.
)
Turn disc brake rotor clockwise to the stop.
)
Tighten retaining screws crosswise with tightening torque of
4 N·m (35 lbf·in)
.
[
a5
]
)
Tighten lock ring with tightening torque of
40 N·m (354 lbf·in)
.
[
a5
]
)
Thoroughly degrease the disc brake rotor using brake cleaner or
spirits.
)
Always use new brake pads if new disc brake rotors are installed.
Installing brake lever
L
Before installing your brake decide which brake lever blade (right
or left) you want to allocate to your front wheel or rear wheel
brake.
)
Make sure that the size of your handlebar (clamping Ø brake
lever) fits your brake lever – see
D
imensions
–
assemBly
, page 21.
)
Push the brake lever onto the handlebar.
Ö
Arrows (thick end of the clamp) point upwards!
[
a3
]
)
First tighten the upper clamping screw
(
2
)
, then the lower one
(
3
)
with tightening torque of
4 N·m (35 lbf·in)
.
Ö
The clamping screw is in contact at the top, there is a gap at the
bottom!
L
The brake lever can be rotated by hand when forced. This reduces
the danger of irreparable damage to the brake lever or handlebar
in the event of a crash.
L
If you reverse the position (right or left) of your brake levers, you
can easily change the position of the rotating dial (BAT) or cover
without tools so they are still on top.
[
a4
]
)
Press the locking disc
(
4
)
, rotate 90° and remove it with the clamp
spring
(
5
)
.
)
Pull and hold brake lever blade lightly.
)
Pull out rotating dial (BAT)
(
6
)
or cover
(
7
)
and replace from above.
)
Position clamp spring with locking disc, press and rotate 90°.
Summary of Contents for Storm HC
Page 2: ......
