Magura Storm HC, Owner'S Manual

Page: 24 / 100

InstallatIon
24
i ns
tallation
i
nstalling the Brake
Important – see
B
asic safety instructions
, page 22!
Danger of injury on sharp or hot disc brake rotor.

Install the quick release skewer of the front wheel on the right.

Always keep away from rotating disc brake rotor.

Always keep away from hot disc brake rotor after braking.
Installing QM adapter
Ø 140 mm (5.5") 160 mm (6") 180 mm (7") 203 mm (8")
Fork
IS 2000 – QM43 (2700 518) QM12 (0722 426) QM5 (0722 321)
PM6" – Direct mount QM40 (2700 515) QM42 (2700 517)
PM7" – – Direct mount QM26 (0724 131)
PM8" – – – Direct mount
FM140F – QM50 (2701 598) – –
Rear triangl
e
IS 2000 – QM12 (0722 426) QM41 (2700 516) QM9 (0722 325)
PM5" Direct mount QM40 (2700 515) QM28 (0724 496) –
PM6" – Direct mount QM40 (2700 515) QM42 (2700 517)
PM7" – – Direct mount QM26 (0724 131)
PM8" – – – Direct mount
FM140R Direct mount QM51 (2701 600) – –
FM160R – Direct mount – –
FM180R – – Direct mount –
)
Make sure that the mounting base is milled smooth, free from
burrs and paint residues and are coated with corrosion protection.
)
Make sure that your MAGURA QM adapter fits the disc brake
rotor Ø and mounting base standard – see table and [
tD
] .
)
Make sure that the retaining screws are always coated with fresh
screwlock (medium strength) before installation.
L
MAGURA QM adapters are generally fitted with an arrow – when
installed the arrow must point upwards (UP). The label on the QM
adapter must always be readable from the left side of your bicycle.
The overview shows the correct installation position of the QM
adapter. [
tD
]
L
The adapter is screwed in combination with the brake calli-
per
[
a2
]
– see
installing brake calliper
, page 26 – the following installa-
tion step is therefore not required.
)
Tighten retaining screws
(
1
)
with tightening torque of 6 N·m
(53 lbf·in) .
[
a1
]
Ö
The arrow on the QM adapter points upwards – the label can be
read from the left.