Magnescale MG10A-P1, Instruction Manual

Page: 78 / 132

30
(E)
MG10A-P1 / MG10A-P2
Command Description
PAU Set the peak value data update stop.
Command format
ab
PAU
c
c
= ON : Peak value data update stop
OFF : Peak value data update stop cancel
LCH Set the current value data latching.
Command format
ab
LCH
c
c
= ON : Current value output data latch stop
OFF : Current value output data latch stop cancel
L Load the reference point.
Command format
ab
L
Read commands
Command Description
LO=? Load the reference point off set value.
Command format
ab
LO=?
Return format
ab
LO=
c
c
= Setting −99.9999 to +99.9999
VER=? Read the software version.
Command format
a
VER=?
Return format
a
VER=
c
c
= Version No.
*
Starting from the leading byte: major
version, minor version
(Example) “0VER=10”
Operation commands
For the same commands as the setting commands (see the list of
operation commands), refer to section 5-4 for details on how to
set the commands.
Command Description
P-P Switch to the peak-to-peak value mode.
Command format
ab
P-P
MAX Switch to the maximum value mode.
Command format
ab
MAX
MIN Switch to the minimum value mode.
Command format
ab
MIN
REAL Switch to the current value mode.
Command format
ab
REAL
RCL Recall the preset values.
Command format
ab
RCL
RES Reset
ab
RES
(zero reset/reference point setting cancel)
START Start
ab
START
*
Set the current value established when the
command is input as both the maximum
and minimum values (zero for the peak-
to-peak value), and start the peak value
measurement.