Magnescale MG10A-P1, Instruction Manual

Page: 82 / 132

34
(E)
MG10A-P1 / MG10A-P2
7. Alarm Display/Output
Alarm
lamp Item Output Cause Solution
I/O connector RS-232C
ON • Measuring unit is
not connected.
• Connection has
been cut.
• Measuring unit
speed over.
Alarm output “Error” in the numerical value part of
the data communication output.
When this is output in mode 3, the
fi fth character following the leading
character of the header changes to
“E”.
[Example]
Mode 1 “00 Error”
Mode 2 “00NM Error”
Mode 3 “00NME Error” The measuring unit was
replaced while the power
was on. Reset.
The measuring unit is not
connected or connection has
been cut. Remove the
cause of the
error, and
reset.
The measuring unit’s spindle
has exceeded the maximum
response speed. Reset.
Count response
speed over Alarm output The count response speed
has been exceeded. Reset.
OFF Overfl ow — The second character in
the numerical value of the
communication data output
changes to “F”.
[Example]
Mode 1 “00 + F0.0000” The number has more than
6 digits. Limit input to 6
digits.