Magnescale MG10A-P1, Instruction Manual

Page: 72 / 132

24
(E)
MG10A-P1 / MG10A-P2
Command Description
Write/Read
RSTRG=/RSTRG=? Select the RS-232C trigger or internal timer.
Command/
a
RSTRG=
c
Return format
c
= 0 : RS-232C trigger low-speed mode,
internal timer not used
1 : RS-232C trigger high-speed mode,
internal timer not used
2 : RS-232C trigger not used, internal timer 0.2 s.
3 : RS-232C trigger not used, internal timer 0.5 s.
4 : RS-232C trigger not used, internal timer 1.0 s.
5 : RS-232C trigger not used, internal timer 5.0 s.
6 : RS-232C trigger not used, internal timer 10 s.
7 : RS-232C trigger not used, internal timer 30 s.
8 : RS-232C trigger not used, internal timer 60 s.
9 : RS-232C trigger not used, internal timer 300 s.
Low-speed mode : Mechanical contact input
(relay, switch, etc.)
High-speed mode : Electronic contact input
(transistor, etc.)
Note
The internal timer cannot be used when using a link connection.
Be absolutely sure that all units have been set to either RS-TRG
low-speed mode or high-speed mode. Normal communications are
impossible when the settings for each unit diff er.
SCALE Set the scale unit (mm or inch).
Command
a
SCALE=
c
format
c
= 0 : mm
1 : 1/25.4 mm
CLOSE Close the parameter setup.
Command CLOSE
Close the parameter setup and store the setup data.
Setup commands