Magnescale MG10A-P1, Instruction Manual

Page: 61 / 132

(E)
13
MG10A-P1 / MG10A-P2
4-2. Details of Functions
For details on the settings and inputs, refer to chapters 5 and 6.
4-2-1. Peak-hold
Th e MG10A holds the peak values at all times.
Th e peak values are checked by switching between the measuring
modes.
Th
e start function makes it possible to restart measurement from
an optional position.
4-2-2. Preset
When the reference point is not used (factory setting)
When the preset value recall input is supplied, the preset value
which has been set is set to the current value.
When the reference point is used
In this case, the function uses the master preset value (refer to
the reference point specifi cations). When the master value is
supplied as the preset value input aft er the reference point has
been loaded for the fi rst time, the distance from the master
value (preset value) to the reference point is calculated, and the
reference point off set value is generated internally and stored.
Aft er the reference point has been loaded for the second and
subsequent times, the reference point off set value is automatically
loaded, which means that the preset value need not be input for
the second and subsequent times.
4-2-3. Reference Point
When the reference point is not used (factory setting)
Aft er the power is turned on, the measuring mode is established
automatically.
(Incremental operation)
When the reference point is used
Aft er the power is turned on, the unit automatically enters the
reference point signal input wait status, and then automatically
enters the measuring mode when the reference point is passed.
Note
Th is can be used only when using a measurement unit with a
reference point.
[How to set the reference point (For DK series)]
Turn on the power.
Th e reference point lamp of the counter module starts fl ashing.
1