Magnescale MG10A-P1, Instruction Manual

Page: 73 / 132

(E)
25
MG10A-P1 / MG10A-P2
Operations are performed by commands which use RS-232C
communication and by the input of signals from the I/O
connector. (If the I/F module has been connected, operations
from the I/F module can also be performed. For further details,
refer to the instruction manual of the I/F module.)
Check the reference point setting while referring to section
“4-2-3. Reference point” function as well.
Note
All contents other than those set by the setup commands are
deleted when the power is turned off .
Type of operation RS-232C I/O connector
Measuring mode changes
Preset value recall
Reset (All channels at once)
Start (All channels at once)
Preset value setting
Comparator value setting
Comparator set number selection
Peak value data update stop (Pause) (All channels at once)
Current value data output latch (All channels at once)
Reference point load
Reference point off set value read
Software version read
Alarm output (Overall alarm)
6. Operation