Magnescale MG10A-P1, Instruction Manual

Page: 57 / 132

(E)
9
MG10A-P1 / MG10A-P2
3-3. Installing the Unit on the DIN Rails
When the multi interface unit is shipped from the factory, the
tabs on the DIN rail anchoring levers are locked.
DIN rail specifi cations: 35 mm
Align the top side of the groove in the unit’s rear panel with
the top of the DIN rails.
1
Install the unit by pushing it into position until a clicking
sound is heard so that the bottom side of the groove in the
unit’s rear panel fi ts snugly on the DIN rails.
Note
Check that the whole unit has been installed properly.
<When removing the unit from the DIN rails>
While holding the unit in place so that it will not fall, pull down
the DIN rail anchoring levers of all the modules until a clicking
sound is heard.
2