Magnescale MG10A-P1, Instruction Manual

Page: 70 / 132

22
(E)
MG10A-P1 / MG10A-P2
5-4-2. Details of Command Settings
ASCII code is used for all the commands. A command is
terminated by “
CR
” or “
CR
” + “
LF
”. (“
CR
”: carriage return; “
LF
”:
line feed)
• Select using communication setting switch No. 2. on main
unit.
OFF : “
CR
” + “
LF
” (factory setting)
ON : “
CR
”
• On the pages to follow, “
c
” and “
d
” are used to indicate the
value to be set.
• When inputting a setting, a numerical value inside the
assigned range must be selected: otherwise, the value will not
be set.
• If no polarity (+ or −) is input, it will be construed as +.
[Data which is input ahead of the commands]
Data Selection range Symbol used in
descriptions
Unit number 0 to F or
*
a
Module number 0 to F or
*
b
• 0 to F are hexadecimal numbers which are equivalent to 0 to
15 under the decimal system.
•
*
is used when the settings are to be established for all units or
all modules.
Setup commands
Command Description
Write/Read
SETUP Start parameter setup.
Command SETUP
Starts parameter setup.
MODE=/MODE=? Set the measuring mode.
Command/
ab
MODE=
c
Return format
c
= 0 : Current value (REAL) mode
1 : Maximum value (MAX) mode
2 : Minimum value (MIN) mode
3 : Peak-to-peak value (P-P) mode
P=/P=? Set the preset value.
Command/
ab
P=
c
Return format
c
= The value diff ers depending on the
input resolution.
Resolution Setting
2-digit integer
+
decimal point
+
4 decimal places
0.1 μm −99.9999 to
+
99.9999
0.5 μm −99.9995 to
+
99.9995
(last digit must always be a 5 or 0)
3-digit integer
+
decimal point
+
3 decimal places
1 μm −999.999 to
+
999.999
5 μm −999.995 to
+
999.995
(last digit must always be a 5 or 0)
4-digit integer
+
decimal point
+
2 decimal places
10 μm −9999.99 to +9999.99