Magnescale MG10A-P1, Instruction Manual

Page: 64 / 132

16
(E)
MG10A-P1 / MG10A-P2
Peak value data update stop (pause)
Th is function enables the following measurements to be
performed while the peak values are held.
It is useful when measuring the peak values for a multiple number
of workpieces or for a multiple number of locations.
When the peak value data update stop function is set to ON
Th e peak value updating is stopped. Th e current value is
constantly updated.
If the maximum value mode, minimum value mode or peak-to-
peak value mode is set as the measuring mode, the Go/No GO
judgment output and the output data are not updated even when
the measuring unit is operated.
When the peak value data update stop function is set to
OFF
Th e peak values are constantly updated.
Maximum value
Current value
Pause ON Pause OFF
4-2-7. Hold
Current value output data latch (latching)
In the current value mode, this function holds output data and
Go/No GO judgment output for that value.
[Latch conditions]
• Th
e start input signal is set as the hold input by the parameter
setting.
• Current value mode
Note
Th is function does not operate when the measuring mode is peak
value mode.
Current value Latch OFF
Latch ON