215028
32
Revision A
1016903
A
B
C
Figure 4.32: Hydraulic Center-Link
14.
Self-Aligning Hydraulic Center-Link:
a.
Adjust position of the center-link cylinder (A) with the
switches on the GSL until hook (B) is above the header
attachment pin.
IMPORTANT:
Hook release (C) must be down to enable self-locking
mechanism.
b.
If the hook release (C) is open (up), stop the engine
and remove the ignition key. Manually push the hook
release (C) down after the hook engages the
header pin.
1028766
A
B
Figure 4.33: Hydraulic Center-Link
15.
Self-Aligning Hydraulic Center-Link:
a.
Lower center-link (A) onto the header with REEL DOWN
switch on the GSL until the center-link locks into
position and the hook release (B) is down.
b.
Check that the center-link is locked onto the header by
pressing the REEL UP switch on the GSL.
c.
Turn off the windrower engine and remove the key
from the ignition.
1028763
A
Figure 4.34: Header Electrical Harness
16.
Self-Aligning Hydraulic Center-Link:
Connect header
electrical harness (A) to header.
