215028
28
Revision A
1028754
A
B
E
C
D
Figure 4.21: Electrical Connection
8.
Connect header adapter harness (A) to plug (B) set in
multicoupler base (C).
9.
Secure header adapter harness (A) to windrower
harness (D) with cable tie (E) to avoid rub/wear points that
could damage the harnesses.
NOTE:
Ensure there is enough slack in harness (A) before securing
with cable tie (E) to maintain a minimum bend radius of
50 mm (2 in.) and avoid contact with multicoupler base (C).
1030573
A
B
Figure 4.22: Electrical Connection
10. Extend center link (A) fully. Check that there is some slack
in the harness (B).
11. Retract center link (A) fully. Check that there is not
excessive amount of harness (B) hanging down.
12. Adjust harness (B) positioning as required.
13. Tighten all the cables along the harness.
1030514
A
B
Figure 4.23: Electrical Connection
14. When disconnected from the header, gather the portion of
adapter harness (A) that connects to the header and secure
it to the center link using adjustable strap (B).
