215028
30
Revision A
1029675
B
A
C
Figure 4.26: Header Boot
–
Right Side, Left Opposite
3.
Lift header support (A) and place 2 x 4 in. blocks (B) under
the header support. A total of four 2 x 4 in. blocks (B) will
be necessary to raise the boot up and into field position.
Ensure the boot
’
s bottom edge (C) is parallel with the
ground.
NOTE:
Do
NOT
stack blocks (B) crosswise as doing so can make the
header unstable when attempting to connect the header
and windrower. Stack blocks (B) parallel with each other.
NOTE:
To better show placement of blocks (B) under the header
supports (A), the illustration at right does not show the two
2 x 4 blocks placed in Step
.
4.
Repeat Step
on opposite side.
CAUTION
Check to be sure all bystanders have cleared the area.
5.
Start the windrower engine.
1015853
Figure 4.27: Header Float Spring
CAUTION
When lowering header lift legs without a header or weight box
attached to the windrower, ensure the float springs tension is
fully released to prevent damage to the header lift linkages.
1015851
A
B
Figure 4.28: HPT Display
6.
Press rotary scroll knob (A) on the Harvest Performance
Tracker (HPT) display to highlight QuickMenu options.
7.
Rotate scroll knob (A) to highlight the HEADER FLOAT
symbol (B), and press scroll knob to select. The header float
adjust screen displays.
