215028
33
Revision A
1016901
A
B
Figure 4.35: Hydraulic Center-Link
17.
Hydraulic Center-Link without Self-Alignment:
a.
Press the HEADER TILT UP or HEADER TILT DOWN
cylinder switches on the GSL to extend or retract the
center-link cylinder until the hook is aligned with the
header attachment pin.
b.
Turn off the windrower engine and remove the key.
c.
Push down on the rod end of link cylinder (B) until the
hook engages and locks onto the header pin.
IMPORTANT:
The hook release must be down to enable the self-
locking mechanism. If the hook release is open (up),
manually push it down after the hook engages the pin.
d.
Check that center-link (A) is locked onto the header by
pulling upward on rod end (B) of the cylinder.
1028763
A
Figure 4.36: Header Electrical Harness
18.
Hydraulic Center-Link without Self-Alignment:
Connect
header electrical harness (A) to the header.
1023024
A
B
Figure 4.37: Header Support
19. Install clevis pin (A) through the support and windrower lift
arm and secure with hairpin (B). Repeat for opposite side.
IMPORTANT:
Ensure clevis pin (A) is fully inserted, and the hairpin is
installed behind the bracket.
CAUTION
Check to be sure all bystanders have cleared the area.
20. Start the engine.
21. Raise the header slightly.
22. Shut down the engine, and remove the key from
the ignition.
DANGER
To avoid bodily injury from fall of raised header, always engage safety props when working on or around raised header,
and before going under header for any reason.
