215028
31
Revision A
1019607
A
Figure 4.29: HPT Display
8.
Press soft key 3 (A) to remove the header float.
NOTE:
If the header float is active, the icon at soft key 3 will
display REMOVE FLOAT; if header float has been removed,
the icon will display RESUME FLOAT.
1018911
A
B
C
D
E
F
Figure 4.30: GSL
A - Reel Down
B - Reel Up
C - Header Tilt Down
D - Header Tilt Up
E - Header Down
F - Header Up
9.
Press HEADER DOWN switch (E) on the ground speed
lever (GSL) to fully retract header lift cylinders.
10.
Self-Aligning Hydraulic Center-Link:
Press the REEL UP
switch (B) on the GSL to raise the center-link until the hook
is above the attachment pin on the header.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
1021743
A
B
Figure 4.31: Header Support
11. Lift the tractor lift linkage (A) to align with header
supports (B).
12. Drive the windrower slowly forward until lift linkage
feet (A) enter the supports (B). Continue to drive slowly
forward until feet engage the supports and the header
nudges forward.
13. Ensure that feet (A) are properly engaged in supports (B).
