215028
12
Revision A
1028261
A
B
B
C
Figure 3.5: Spreader Bar Attached to Disc Header
2.
Attach spreader bar (A) to forks.
IMPORTANT:
Length of spreader bar must be approximately
457 cm (15 ft.).
3.
Approach the header from its underside with the forklift.
4.
Attach chains with hooks to the spreader bar (A) and hook
into shipping brackets (B) on both sides of the disc header.
CAUTION
Stand clear when lowering the disc header.
IMPORTANT:
Chain length must be sufficient to provide a minimum
clearance (C) of 1219 mm (48 in.) between the rotary disc
header and the spreader bar.
IMPORTANT:
Do
NOT
attach chain hooks to the hazard light standards.
5.
Raise forks until lift chains are fully tensioned.
1028609
A
B
B
Figure 3.6: Lowering Rotary Disc Header to the
Ground
6.
Back up the forklift
SLOWLY
, and lower the rotary disc
header (A) into working position on the wooden blocks (B)
placed in Step
NOTE:
Watch out for contact between hazard light brackets and
the lowering chains while the header is being lowered. Take
care to avoid damaging the lights and brackets.
7.
Remove chains from the header.
