MacDon PW8, Unloading And Assembly Instructions

Page: 86 / 170

214658
78
Revision A
1012153
A
B
Figure 6.8: Right Access Panel
4. Remove two bolts (A) from access panel (B).
5. Remove access panel (B).
1012160
A
B
C
D
E
Figure 6.9: Header Height Sensor Assembly
–
Right Side
6. Loosen nuts (A).
7. Rotate sensor (B) until desired voltage range is
achieved. Refer to
6.1.2 Height Sensor Output Voltage
Range
–
Combine Requirements, page 74 .
NOTE:
If voltage range is too large or too small, you may need
to relocate linkage rod (C) to a different hole in sensor
control arm (D). If that doesn
’
t work, relocate linkage
rod (C) to a different hole in sensor control arm (E).
1012153
A
B
Figure 6.10: Header Height System
8. Once complete, install access panel (B) and secure it
with bolts (A).
NOTE:
Auger removed for illustration purposes.
PREDELIVERY INSPECTION