MacDon PW8, Unloading And Assembly Instructions, Page: 131 / 170

214658
123
Revision A
1023985
A
B
C
Figure 6.100: New Holland Combine Controls
5. To change one of saved header height set points while
combine is in use, use HEADER HEIGHT AND
HEADER LATERAL FLOAT rocker switch (A)
(slow up/down) to raise or lower header to desired
value. Press AUTOMATIC HEADER HEIGHT
CONTROL button (B) for a minimum of 2 seconds to
store new height position. A beep will confirm setting.
NOTE:
Do NOT press too hard on AUTOMATIC HEADER
HEIGHT CONTROL button (B), or float mode will be
disengaged.
NOTE:
It is not necessary to press rocker switch (C) again after
adjusting.
Configuring Reel Fore-Aft, Header Tilt, and Header Type (New Holland CR Series)
This procedure applies only to 2016 New Holland CR models 6.90, 7.90, 8.90, and 9.90.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
1015005
A
B
Figure 6.101: New Holland Combine Controls
1. Simultaneously press both UNLOAD (A) and
RESUME (B) buttons on hydro handle.
PREDELIVERY INSPECTION