MacDon PW8, Unloading And Assembly Instructions

Page: 106 / 170

214658
98
Revision A
Setting Sensing Grain Header Height to 50 (John Deere 60 Series)
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator
’
s manual for updates.
To set sensing grain header height, follow these steps:
1003642
A
B
C
D
E
Figure 6.52: John Deere Combine Display
1. Press DIAGNOSTIC button (A) on monitor. DIA
appears on the monitor.
2. Press UP button (B) until EO1 appears on monitor, and
press ENTER (D). This is header adjustment.
3. Press UP (B) or DOWN (C) button until 128 is displayed
on top portion of monitor. This is the reading for the
sensor.
4. Press ENTER (D) to select 128 as sensor reading (this
will allow you to change display to a three-digit number
so it has a 50 in it).
5. Press UP (B) or DOWN (C) button until desired number
is displayed, and press CAL (E) button.
6. Press ENTER (D) to save the changes. The height is
now set.
1003651
A
B
Figure 6.53: John Deere Combine Display
NOTE:
Do NOT use active header float function (A) in
combination with MacDon auto header height
control (AHHC)
—
the two systems will counteract one
another. The header symbol (B) on display should NOT
have a wavy line under it and should appear exactly as
shown on Active Header Control Display in Figure
6.53,
page 98 .
PREDELIVERY INSPECTION