262175
125
Revision A
A
B
C
D
E
F
ϭϬϰϮϭϲϵ
Figure 5.61: Windrower Lift Linkage and Header Leg
17. Proceed as follows:
•
If the header supports are installed on the windrower:
Install pin (B) through the header leg, engaging the
header support in the lift linkage. Secure the pin with
ring (A).
•
If the header supports are installed in the header:
Secure windrower lift linkage (C) to header supports (D)
using clevis pin (E) and hairpin (F).
NOTE:
To ensure that the pin doesn
’
t snag the windrow, install
the clevis pin on the outboard side of the draper header
support.
Repeat this step on the other header leg.
1029799
A
Figure 5.62: Safety Prop Lever
18. Disengage the safety props on both lift cylinders as follows:
a.
Turn lever (A) away from the header to raise the safety
prop until the lever locks into the vertical position.
b.
Repeat the previous step for the opposite cylinder.
NOTE:
If the safety prop will
NOT
disengage, raise the header to
release the prop.