262175
176
Revision A
1015479
A
B
Figure 5.173: Left Platform
2.
Approach platform (A) on the left side of the windrower.
Ensure that the cab door is closed.
3.
Push latch (B) and pull platform (A) toward the walking
beam until it stops and the latch engages.
1028852
A
B
C
Figure 5.174: Hose Support Attachment
4.
Retrieve hydraulic hoses (A) from the header and route the
hose bundle under the windrower frame.
NOTE:
Adding anti-seize compound to the hose holder pin will
make future removal easier.
5.
Insert pin (B) into hole (C) in the windrower frame.
IMPORTANT:
Route the hydraulic hoses as straight as possible, avoiding
wear points that could damage the hoses. To prevent
abrasion damage, the hoses should have enough slack to
pass by the multicoupler bracket without contacting it. To
adjust the slack in the hoses, loosen the clamps below
pin (B), adjust the hoses, then retighten the hose holder.
1027578
A
B
C
Figure 5.175: Couplers
–
Auger/Rotary Disc/Draper-
Ready Configuration
6.
Ensure that hose (A) is disconnected from windrower
receptacle (B) and placed in storage cup (C) on the
multicoupler.
