262175
116
Revision A
1022271
A
B
C
Figure 5.45: Header Support
25. Reinstall clevis pin (B) into header support (C) and secure it
with hairpin (A). Repeat this step at the opposite side.
5.1.5
Removing Forming Shield from the Windrower
The forming shield controls the width and placement of the windrow. The instructions in this section will show you how to
properly remove the forming shield from the windrower.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
NOTE:
It is
NOT
always necessary to remove the forming shield after detaching the header from the windrower.
1.
Shut down the engine, and remove the key from the ignition.
B
C
ϭϬϰϮϮϰϵ
A
D
Figure 5.46: Rubber Strap Securing Forming Shield
onto Windrower Leg
2.
Mark the strap location, then remove and retain hairpin (A)
and washer (B) from straight pin (C).
3.
Pull rubber strap (D) away from straight pin (C).
4.
Lower the rear end of the forming shield.
5.
Reinstall washer (B) and hairpin (A) on straight pin (C).
6.
Repeat Step
to Step
on the
opposite windrower leg.
