4.5.6
Activating the Reel Speed Control Lockout
NOTE:
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER
SETUP?
is
displayed
on
the
upper line.
• NO/YES is displayed on the lower line.
3.
Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 4.78: CDM Programming Buttons
4.
Press SELECT (B) until SET CONTROL LOCKS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
5.
Press right (A) arrow to select YES. Press SELECT (B).
Figure 4.79: Control Locks
6.
Press SELECT (D) until REEL SPEED is displayed on
the upper line.
• ENABLED/LOCKED is displayed on the lower line.
7.
Press left (B) arrow to enable REEL SPEED
control switch.
Press
right
(C)
arrow
to
lock
REEL
SPEED
control switch.
8.
Press PROGRAM (A) to exit Programming Mode, or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 4.80: Reel Speed Control Lock
147764
102
Revision A