4.4.15
Setting the Engine Intermediate Speed Control (ISC) RPM
NOTE:
The engine
MUST
be running to perform this procedure.
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER
SETUP?
is
displayed
on
the
upper line.
• NO/YES is displayed on the lower line.
3.
Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 4.59: CDM Programming Buttons
4.
Press SELECT (C) until SET ENGINE ISC RPM? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
5.
Press right (B) arrow to select YES. Press SELECT (C).
• PRESS HAZARD TO SET is displayed on the
upper line.
• ISC RPM #### is displayed on the lower line.
NOTE:
The previously selected ISC rpm will be flashing.
Figure 4.60: Engine ISC RPM
6.
Press right (C) arrow to cycle between rpm options.
Press HAZARD (B) to set.
7.
Press Select (D).
• EXIT ENGINE ISC? is displayed on the upper line.
• NO/YES is displayed on the lower line.
8.
Press
right
(C)
arrow
to
select
YES.
Press
SELECT (D).
9.
Press PROGRAM (A) to exit Programming Mode.
Figure 4.61: ISC RPM
147764
94
Revision A