4.
Drive the windrower slowly forward until the windrower
feet (A) enter the header boots (B). Continue driving
slowly forward until the feet engage the boots and the
header nudges forward.
Figure 3.116: Header Boot
5.
Use the following GSL functions to position the
center-link hook above the header attachment pin:
• Header tilt up (A) to retract the center-link
• Header tilt down (B) to extend the center-link
6.
Stop engine and remove key from ignition.
Figure 3.117: GSL
7.
Push down on rod end of link cylinder (B) until hook
engages and locks onto header pin.
IMPORTANT:
Hook release must be down to enable self-locking
mechanism. If the release is open (up), manually
push it down after hook engages header pin.
8.
Check that center-link (A) is locked onto header by
pulling upward on rod end (B) of cylinder.
Figure 3.118: Hydraulic Center-Link
147764
57
Revision A