UNLOADING AND ASSEMBLY
Form # 169242
Model Year - 2009
42
CAUTION
Check to be sure all bystanders have cleared
the area.
IMPORTANT
If engine fails to start within 30
seconds, cease cranking and wait two
minutes to allow the starting motor to
cool before attempting to re-start the
engine.
6. When glow plug light goes out, turn key to
START and crank engine until it starts.
Leave throttle at IDLE.
7. Engine will cycle through a period where it
appears to labour.
M150 – CUMMINS ENGINE – Cold Start
NOTE
This engine is not equipped with cold
start assist system.
1. Follow procedure for Normal Start.
2. Engine will cycle through a period where it
appears to labour until engine warms up.
NOTE
Throttle is non-responsive during this
time as engine is in “WARM UP”
mode. This mode will last from 30
seconds to 3 minutes depending on
temperature. After engine has
stabilized and idling normally, throttle
becomes active.
IMPORTANT
Do not operate engine above 1500
rpm until engine temperature gauge is
above 100°F.
M100 – CUMMINS ENGINE –Cold Start
1. Perform steps a. to e. on previous page.
2. Set throttle to start position (G) – fully back
(low idle).
3. Turn ignition key (H) to RUN.
4. Single loud tone sounds, engine warning
lights illuminate and CDM displays HEADER
DISENGAGED or DISENGAGE HEADER
and IN PARK.
5. Grid heater light on CDM will cycle on/off/on
after 2 seconds for a pre-set length of time.
The operating period for the grid heater light
will change depending engine temperature.
CAUTION
Check to be sure all bystanders have cleared
the area.
IMPORTANT
If engine fails to start within 30
seconds, cease cranking and wait two
minutes to allow the starting motor to
cool before attempting to re-start the
engine.
6. When grid heater light goes out, turn key to
START and crank engine until it starts.
Leave throttle at IDLE.
7. Engine will cycle through a period where it
appears to labour.
IMPORTANT
Do not operate engine above 1500
rpm until engine temperature gauge is
above 100°F (38
°
C).
H
G
START
RUN
OFF
