UNLOADING AND ASSEMBLY
Form # 169242
Model Year - 2009
61
STEP 27. PROGRAM CDM
The monitoring system requires programming
for each header and the header must be
attached to the windrower tractor. Programming
the system may be accomplished with or without
the engine running. If the engine is running, the
transmission must be in neutral. If the engine is
not running, the ignition must be on. Exit
programming mode at any time by pressing the
PROGRAM switch or by turning off the ignition.
The system only needs to be programmed once
for each header. The operator may make
changes later on to a particular setting to suit
windrowing conditions or modifications to the
machine. Most functions have been pre-
programmed at the factory but can be changed
by the operator if required.
The following functions can be programmed by
the dealer provided he has the applicable
information from the operator and the header is
installed:
•
DWA INSTALLED (M150, M200 ONLY)
•
HDR CUT WIDTH
•
HAY CONDITIONER INSTALLED
•
CALIBRATE SENSORS
Proceed as follows to program the CDM:
IMPORTANT
Header must be attached to the
tractor. See STEP 9.
a. Turn ignition key to RUN, or start the engine.
Refer to STEP 12.J. II START ENGINE.
b. Press PROGRAM and SELECT on CDM to
enter programming mode. Header ID code is
displayed.
c. Press SELECT. TRACTOR SETUP? is
displayed.
d. Press . SET KNIFE SPEED? is displayed.
e. Press SELECT until DWA INSTALLED? is
displayed.
f. Press or .
g. Press SELECT to advance to the next L1 item.
h. Press PROGRAM to exit programming mode.
i. Refer
to:
A. M150, M200 Detailed Programming
Instructions, or
B. M100 Detailed Programming Instructions
on following pages.
NOTE
The functions requiring programming
are hi-lited.
NOTE
If necessary, refer to the M Series
Windrower Operator’s Manual for
programming CDM to specific crop
types and conditions.
