10.2 Programmed scan
Programmed scan repeatedly scans between
two user programmed frequencies (memory
channels “1A–3A” and “1b–3b”) or scans between
upper and lower band edges. This scan is useful
for checking for signals within a specifi c frequency
range such as repeater output frequencies, etc.
Scans between lower (start) and high (stop)
frequency.
①
Push
[D•CLR]
to select VFO mode, if necessary.
②
Push
[A•FUNC]
and
[5•SCAN]
to start the scan, then
a selected scan edge appears as “P1,” “P2,” “P3”
or “AL.”
• To change the scan edge, push
[A•FUNC]
and
[8•SET]
several times until the desired scan edge
appears.
• “AL” for full scan, “P1”, “P2” and “P3” for
programmed scan between the programmed
scan edge channels as “1A”–“1b,” “2A”–“2b”
and “3A”–“3b.”
• To change the scan direction, push
[▲]
or
[▼]
.
• When
[VOL]
is assigned as tuning dial, rotate
[VOL]
to change the scan direction. (p.27, 61)
③
Push
[D•CLR]
to stop the scan.
SCAN OPERATION
Push
NOTE: Scan edges, 1A–3A/1b–3b, must be
programmed in advance. Program them in the
same manner as regular memory channels.
(p.36)
If identical frequencies are programmed into the
scan edges, programmed scan will not proceed.
46
SECTION 10SECTION 10
Summary of Contents for MT-V82N
Page 1: ...User Manual VHF FM Transceiver...
Page 2: ......
