7.1 General
When using a repeater, the transmit frequency is
shifted from the receive frequency by the offset
frequency. It is convenient to program repeater
information into memory channels.
①
Set the receive frequency (repeater output
frequency).
②
Push
[A•FUNC]
and
[4•DUP]
several times to select
“–” or “+.”
• “–” indicates the transmit frequency is shifted
down; “+” indicates the transmit frequency is
shifted up.
• Blinking “–” or “+” indicates the reversed
duplex mode is selected in
SET MODE
(p.56).
③
Push
[A•FUNC]
and
[1•TONE]
several times to
activate the subaudible tone encoder, if
required.
• “ ” appears.
• Select the desired subaudible tone frequency,
if necessary. (p.33)
④
Push and hold
[PTT]
to transmit.
• The displayed frequency automatically
changes to the transmit
frequency (repeater input frequency).
• If “OFF” appears, check the offset frequency
(see next page for details) and direction.
⑤
Release
[PTT]
to receive.
⑥
Push and hold
[MONI]
to check whether the other
station’s transmit signal can be directly received.
7.2 Reversed duplex mode
(USING SET MODE)
When the reversed duplex mode is selected, the
receive frequency shifts. (Transmit frequency shifts
in normal duplex mode). Each receive and transmit
frequency is shown in the table below with the
following conditions;
MT-V82N
Input frequency : 145.30 MHz
Direction
: – (negative)
Offset frequency : 0.6 MHz
REPEATER OPERATION
31
SECTION 7SECTION 7
Summary of Contents for MT-V82N
Page 1: ...User Manual VHF FM Transceiver...
Page 2: ......
