R
GRAFIK Eye
®
QS System Installation and Operation Guide 22
Adjusting Window Treatment Settings
Name a Group of Window Treatments
1. Enter programming mode (see page 12).
2. Use the master buttons to highlight “Shade labels” and press
the OK button to accept.
3. Use the master buttons to select your desired shade group.
Press the OK button to accept.
4. Use the master buttons to highlight “Custom” and press the OK button to accept.
5. Use the master buttons to scroll through the characters (lowercase and uppercase
letters, plus numbers 0-9). The character you are currently changing will be
underlined on the screen. Press OK to select the character you want, then repeat
for all available characters. Choose a space (no character) and press OK for any
remaining characters. Press the OK button to accept.
6. The info screen will display a confirmation screen that your name has been saved.
7. Exit programming mode (see page 12).
Main menu
Zone setup
Shade labels
Select shade grp:
Shade grp 1
Label shade grp:
Custom
Label shade grp 1
1: A
1 / 11
OK
Saved
Saved
A
Master
buttons
OK
button
Remotely Restore EDUs to Factory
Defaults
Warning!
Restoring an EDU
(electronic drive unit for a window
treatment) to its factory defaults
will erase any previous
programming or assignments you
have made for that EDU.
Note:
Entering this mode may
cause window treatments to
move approximately 203,2 mm
(8 in.) up or down.
Be sure that
each window treatment is
positioned so fabric can safely
move 203,2 mm (8 in.) up or
down before entering this mode.
1. On any shade column,
press and hold
simultaneously the top
and lower buttons.
The LED next to the
top button will flash.
2. Press and hold the top
button for 5 seconds.
All shade column
LEDs will blink rapidly.
3.Select the EDU you want to restore to
factory defaults using the top button on
the shade column. Each time you press
and release the top button, a different
EDU in your system will open and close
in an 203,2 mm (8 in.) range to indicate it
is selected. Press the top button until the
EDU for the window treatment you wish
to restore to factory defaults moves. (You
can also use the bottom button, which
moves through the assigned EDUs in the
opposite order.)
4.Press and hold simultaneously the raise
and lower buttons for 5
seconds to restore the moving
shade to factory defaults.
5.Repeat steps 3 and 4 to restore factory
defaults to any other window treatments.
6.Press and hold simultaneously the top
and lower buttons on the shade column
to exit this mode.