R
GRAFIK Eye
®
QS System Installation and Operation Guide 28
Set Save Mode
1. Enter programming mode (see page 12).
2. Use the master buttons to highlight “Save
mode” and press the OK button to
accept.
3. Use the master buttons to highlight the
save mode you would like. The save
modes are listed and explained below.
4. Press the OK button. The info screen will
display a confirmation screen that your
save mode has been saved.
5. Exit programming mode (see page 12).
Main menu
Scene setup
Save mode
Save mode
Save always
Save Modes
Save always (default mode) . . Quick scene programming mode; automatically save changes made to to lighting levels or fade time
(master raise/lower changes are temporary)
Save by OK . . . . . . . . . . . . . . Zone adjustments are temporary unless the OK button precedes them
Save never . . . . . . . . . . . . . . . Do not save any temporary changes to lighting levels or fade time
Four scenes . . . . . . . . . . . . . . Zone raise/lower buttons are disabled (typically used for rented spaces)
Master raise/lower buttons, wallstations, and IR receiver are still enabled for adjustment of light level,
but these changes are not saved
Button disable . . . . . . . . . . . . Only the timeclock button, IR receiver, and wallstations can be used to make temporary changes
(typically used in a public space)
Note:
Off scene can be changed only through scene setup in program mode. Save modes will change only the fade time in Off
scene settings.
OK
Master
buttons
OK
button
Saved
Saved
