Lutron Electronics EcoSystem Programmer, Programming Manual, Page: 59 / 72

Programming Guide
57
Replacing the Bus Supply
In the unlikely event the EcoSystem bus should fail, a newly installed
bus supply can “learn” the settings of the system by downloading it
from the ballasts. This also clears any existing programming in the
bus supply.
1 1 Make sure the new bus supply
has been properly installed,
but do not perform any
programming steps.
2 2 From the Main Menu, tap
S Syys stte em m then R Re ep plla ac ce e B Bu us s
S Su up pp pllyy.
3 3 Read the instructions. Point
the programmer at any IR
control device, then tap
to
continue.
4 4 Read the caution, then tap
to begin the replacement
procedure.
5 5 If all ballasts flash and go to
their high level, tap .
6 6 Once all ballasts go to their
minimum level and then flash,
tap
.
2 2