Programming Guide
47
Accessing the Stand-Alone Programming Menu
The stand-alone programming menu enables you to configure
special settings for ballasts and modules used in a stand-alone
configuration.
1
1 From the Main Menu, tap
B
Ba
alllla
as
stts
s then S
Stta
an
nd
d--A
Allo
on
ne
e
P
Prro
og
grra
am
mm
miin
ng
g. Acknowledge
the note regarding stand-alone
programming, and tap
to
continue.
2
2 Read the instructions. Point
the programmer at an IR
control device connected to
the ballast to be configured,
then tap
to continue.
3
3 Point the programmer at the IR
control device and tap
to
begin communication.
The Stand-Alone Programming
menu displays and you can:
• Set the emergency level
• Set the high end trim
• Perform stand-alone lamp
seasoning
• Set up a daylight or
occupancy sensor, or
configure XPJ settings
• Enable or disable 3 wire
input
• Reset the selected ballast
Refer to the following topics for
detailed stand-alone
programming procedures.
1
1