18
EcoSystem
®
Programmer
Setting Light Levels for Daylight Sensors
To save energy, a light level can be set for each row of fixtures in a
daylight sensor group. Throughout the day, fixtures automatically
adjust their light level based on how much daylight the space is
receiving. Light levels can be set from any IR receiver. It is not
necessary to directly access the sensor being set.
NOTE: Group fixtures before setting light levels. Refer to page 16.
1
1 From the Main Menu, tap
D
De
evviic
ce
e S
Se
ettu
up
p and then
D
Da
ayylliig
gh
htt S
Se
en
ns
so
orr.
2
2 Read the instructions, then
tap
to continue.
3
3 Point the programmer at any
IR receiver and tap
to
begin communication.
4
4 If all fixtures go to minimum
brightness and a fixture
connected to a daylight sensor
flashes, tap
.
5
5 Scroll to the daylight sensor to
be set (its group fixtures will
flash). Then tap
to
configure the selected sensor.
6
6 If fixtures in row 1 of the
selected sensor group go to
full brightness and all other
fixtures go to minimum
brightness, tap
.
By default, all fixtures initially
grouped to the daylight sensor
are in row 1. Up to 4 different
rows are supported in each
daylight sensor group. It is not
necessary to have fixtures in
every row.
1
1
5
5