Setting an Additional Timeout Period for Occupant
Sensors
Occupant sensors can be set up to turn fixtures off automatically
after a period of inactivity. The default timeout is zero seconds. Any
timeout programmed into the ballast will be in addition to that of the
occupant sensor. Consult the installation guide for your occupant
sensor to determine the total delay.
1
1 From the Main Menu, tap
D
De
evviic
ce
e S
Se
ettu
up
p and then
O
Oc
cc
cu
up
pa
an
ntt S
Se
en
ns
so
orr.
2
2 Read the instructions, then
tap
to continue.
3
3 Point the programmer at any
IR control device and tap
to begin communication.
4
4 If a group of fixtures goes to
full brightness and other
fixtures go to minimum
brightness, tap
.
5
5 Scroll to the sensor to be set
(its group of fixtures will flash).
Then tap
to configure the
selected sensor.
6
6 If all fixtures go to minimum
brightness and a fixture
connected to an occupant
sensor flashes, tap
.
7
7 Select S
Se
ett T
Tiim
me
eo
ou
utt.
8
8 Note the warning, then tap
to continue.
6
6
7
7
24
EcoSystem
®
Programmer