Lutron Electronics EcoSystem Programmer, Programming Manual, Page: 58 / 72

56
EcoSystem
®
Programmer
Manually Adjusting the Light Level
The light level can be manually adjusted for all fixtures in an IR
receiver group. The adjusted light level remains in effect until one of
the following occurs:
• An emergency situation occurs
• A daylight sensor lowers the fixture to compensate for natural
lighting
• The room becomes unoccupied, or
• A user manually adjusts the level again via EcoSystem
programmer, wall control, or IR tramission.
1 1 From the M Ma aiin n M Me en nu u, tap
L Liig gh httiin ng g C Co on nttrro oll.
2 2 Read the instructions, then
tap to continue.
3 3 To control only the fixture(s)
assigned to the sensor, select
IIR
R R Re ec ce eiivve err W Wa allll C Co on nttrro oll
G Grro ou up p.
To control all fixtures,
overriding other sensor inputs,
select A
Allll B Ba alllla as stts s. (The
override will end after 15
minutes of inactivity, unless
exited manually.)
4 4 Point the programmer at the
IR receiver whose group
fixture(s) are to be adjusted (or
any IR receiver if all fixtures are
being controlled), then tap a
light level.
5 5 Tap M Ma aiin n M Me en nu u or to exit.
4 4
5 5
1 1