Programming Guide
37
Setting Occupied and Unoccupied Levels
The occupied and unoccupied settings determine the level the lights
will go to when they are in the occupied or unoccupied state. By
default, the occupied level is high end and the unoccupied level is
OFF.
These settings are the same as those set during the
programming of occupant sensors.
1
1 From the Configure Menu, tap
M
MO
OR
RE
E O
OP
PT
TIIO
ON
NS
S and then
S
Se
ett O
Oc
cc
cu
up
piie
ed
d L
Le
evve
ell or S
Se
ett
U
Un
no
oc
cc
cu
up
piie
ed
d L
Le
evve
ell.
NOTE: For procedures on how to
select one or all ballasts and then
display the Configure menu, refer
to page 28.
2
2 Tap
to begin setup.
3
3 If selected ballasts flash and
go to their high level, tap
.
4
4 Tap an occupied or
unoccupied light level. If
needed, use the arrow keys
to adjust the selected level
incrementally.
NOTE: The intensity changes as
you make your selection. If
Unaffected, the ballast’s light level
will not change when becoming
occupied/unoccupied.
5
5 Select D
Do
on
ne
e.
6
6 Select D
Do
on
ne
e.. Or, select
another option to continue
configuring ballasts.
7
7 When done, if the last
configured ballast(s) flash and
go to their high level, tap
.
1
1
4
4
5
5