Troubleshooting
Problem Determination
4-6
WaveLAN/ISA Card User’s Guide
Performance loss or "Out-
of-range" condition
(typically when the station
is relocated)
No closer WavePOINT to hand over to.
Install another WavePOINT to extend the
Auto-connect area.
The WaveLAN Card’s “Auto-conect feature has been
disabled.
Check the DOMAIN ID parameter in the
NET.CFG file (Netware ODI ) or
PROTOCOL.INI (NDIS) file. The value
‘0000’ disables Auto-connect. Modify the
Domain ID an Beacon Key value, to match
the settings used by the WavePOINTs.
Roaming not enabled at the new, closer WavePOINT Check Installation records. Ask the Network
Administrator to run WaveMONITOR to
check that WavePOINT is sending Beacons,
Signal Quality is O.K. and Domain ID
correct.
Domain ID or Beacon Key mismatch with new
WavePOINT
Station's MAC address not in new WavePOINT's
Access Control Table
Check Access Control Table data or reload
configuration with Access Control disabled.
Encryption Key mismatch on new WavePOINT
Check Security feature status and
Encryption key of new WavePOINT
corresponds to that of other WavePOINTs
and WaveLAN stations in the Domain.
isa-src.bk : isa-ch4.frm Page 6 Monday, October 14, 1996 1:23 PM
