Slot Card Specifications
OC3-ATM2 card
APX 1000™ Getting Started Guide
B-15
OC3-ATM2 card
An OC3-ATM2 card provides one 155.52Mbps interface for connecting to an ATM switch. At
a minimum, you must enable the line and specify a dedicated (nailed) group. MAX TNT units
use the nailed group to direct traffic to the interface.
The OC3-ATM2 cards can be used to route IP over ATM or perform layer 2 switching between
ATM and Frame Relay network. The following three versions of this card are available:
•
TNT-SL-UOC3CP-C—with a copper interface
•
TNT-SL-UOC3SF-C—with an optical fiber interface, for short-haul connections
•
TNT-SL-UOC3LF-C—with an optical fiber interface, for long-haul connections
Status indicators
The OC3-ATM2 slot cards provide status indicators described in Table B-17. All status lights
except LA are illuminated upon power-up or reset and remained illuminated until the card
passes POST. If no status lights are illuminated, the OC3 interface is either disabled or is
receiving an Alarm Indication signal (AIS) or Idle signal.
Interfaces per card
One unchannelized DS3 port with integrated CSU/DSU.
Maximum of four cards per chassis.
Card dimensions
5.6 inches high by 10.7 inches long (14.2cm x 27cm)
Card weight
~2 pounds (0.9kg)
Operating humidity
0-90%, noncondensing
Operating temperature
32-122° F (0-50° C)
Table B-16. DS3-ATM2 card specifications (continued)
Category
Specification
Table B-17. OC3-ATM2 status lights
Status
indicator
Description
LOF
ON indicates the OC3 interface has detected a Far End Receive Failure
indication transmitted from the other side.
AIS
ON indicates the local device has received an Alarm Indication signal.
ACTIVE
ON indicates the OC3 interface is enabled and has not detected any error
conditions.
OOF
ON indicates the OC3 interface is out of frame alignment.
LOS
ON indicates the OC3 interface is experiencing a loss of the receive
signal.
