Chapter 2
22
CellPipe
20H User Guide
User name: (set user name from ISP)
Password: (set password)
Retype password: (reconfirm password)
The following (example) will be displayed for checking
your setting
Setup Configuration
FUNCTION: PPPOA
Ethernet IP: 192.168.1.1
Subnet Mask: 255.255.255.0
# VPI
VCI
AUTH
USERID
1: 7
34
CHAP
xavi
Preserve the configuration (y/n) : (“y” to use the setting
or “n” to leave without change. Start again to set
parameters)
Configuration will have no effect until after save and
restart.
All the parameters will not be effective under the setting
being saved and restart again. Above message is to
remind operator
4.4.3
NAT function
NAT function will be enabled automatically when PPPoA
routing set. This function will enable PC users in your
LAN environment to access outside with only one IP
address (IP sharing) and one access account.
If you have any application or server in your LAN
environment which is available for outside uses, please
configure the PAT (port address translation) table to
enable this kind of service by following the example
below, otherwise continue to section 4.4.4
