Chapter 2
CellPipe
20H User Guide
23
Use the following example to set NAT function for PPPoA
routing.
> pat ( with “enter” key to go to pat director)
> pat> addpatin pppoa 434/udp 210.18.35.10
(Addpatin – command for add incoming pat table)
(pppoa – set PAT table for PPPoA routing. PAT table is
service related )
(434- port number of services or application to offer)
(udp – protocol used. Use ”tcp” for tcp/ip services)
(210.18.35.10 – IP address of server offered for
access from outside. Use correct IP Address instead)
4.4.4
Save the configuration to router permanently and
make settings effective by following steps below
>pat> home (with “enter” key to execute)
You can use “show” command to check your setting
again.
>> save (with “enter” key to execute)
Wait until the following message displayed on your
screen completely. Don’t power off the modem during this
stage.
Saving configuration...
Configuration saved.
Updating flash filing system ...
