Chapter 2
20
CellPipe
20H User Guide
(192.168.1.3 – WAN IP address of IPoA routing.
Replaced with specific WAN IP address set for IPoA
routing in this example. PAT table is service related )
(434- port number of services or application to offer)
(udp – protocol used. Use ”tcp” for tcp/ip services)
(210.18.35.10 – IP address of server offered for access
from outside. Use correct IP Address instead)
4.3.4
Save the configuration to router permanently and
make settings effective by following steps below:
>pat> home (with “enter” key to execute)
You can use “show” command to check your setting
again.
>> save (with “enter” key to execute)
Wait until the following message displayed on your
screen completely. Don’t power off the modem during this
stage.
Saving configuration...
Configuration saved.
Updating flash filing system ...
SDRAM size = 0x800000
Booting...
System starts...
